Solid maple exhibits a density of approximately 0.72 g/cm³ and a Janka hardness rating near 1450 lbf, providing resistance to indentation from dropped weights and heavy equipment.
Typical moisture content after kiln drying ranges from 6 % to 8 %, which minimizes seasonal expansion and contraction and helps maintain dimensional stability under varying humidity.
Logs are sawn to rough dimensions, then kiln‑dried to the target moisture content before being planed to precise thickness and width.
Tongue‑and‑groove milling creates a interlocking edge that distributes loads across adjacent boards, while a multi‑coat polyurethane finish adds abrasion resistance and a low‑gloss surface.
In weightlifting areas, the high modulus of elasticity of maple spreads impact forces over a larger area, reducing peak pressure on the sub‑floor and protecting equipment bases.
For cardio zones, the closed‑cell structure provides consistent slip resistance (coefficient of friction ≈0.6 dry) while absorbing vibration from treadmills and ellipticals.
Multipurpose courts benefit from the uniform surface hardness, which ensures predictable ball bounce and facilitates quick line‑marking without compromising durability.
| Parameter | Typical Value | Notes |
|---|---|---|
| Density | 0.70‑0.75 g/cm³ | Dependent on growth region |
| Janka Hardness | 1350‑1500 lbf | Resistance to indentation |
| Moisture Content (MC) | 6‑8 % | After kiln drying |
| Thickness Tolerance | ±0.2 mm | Measured at 23 °C, 50 % RH |
| Coefficient of Friction (dry) | 0.55‑0.65 | ASTM D2047 |
| Compressive Strength (parallel to grain) | 40‑45 MPa | Supports heavy load racks |
Each batch undergoes moisture‑meter verification to confirm MC is within the 6‑8 % window before packaging.
Dimensional checks are performed on a statistical sample, measuring thickness, width, and length to ensure tolerances are met.
Surface finish is inspected for gloss uniformity and adhesion using cross‑hatch tape tests, guaranteeing the coating meets the specified abrasion resistance.
To discuss your specific requirements and receive a detailed quotation, contact our technical sales team.