Hard maple (Acer saccharum) is valued for its uniform grain, high density, and resistance to wear. When processed into flooring, its mechanical properties translate into long service life under heavy foot traffic.
The Janka hardness of hard maple averages 1,450 lbf, placing it among the harder domestic hardwoods. Its specific gravity is approximately 0.68, giving a density of about 42 lb/ft³ at 12% moisture content.
Dimensional stability is expressed as tangential shrinkage of roughly 5.8% and radial shrinkage of 2.9% when moisture content changes from green to oven‑dry. Proper kiln drying to 6‑9% MC limits movement in service.
Logs are sawn to rough dimensions, then air‑ or kiln‑dried to target moisture content. Subsequent planing achieves exact thickness tolerances, typically ±0.005 in. Edge profiling (square, eased, or beveled) is performed after final sanding.
Surface preparation includes progressive sanding to 120‑grit before applying a UV‑cured polyurethane finish. Finish thickness is controlled to 2‑3 mils dry film, providing abrasion resistance measured by Taber wear index <100 mg loss per 1000 cycles.
In retail environments, hard maple flooring withstands cart traffic and frequent cleaning cycles without showing premature wear. Its light color reflects ambient illumination, reducing lighting energy demand in large stores.
Educational institutions specify the material for gymnasiums and multipurpose halls where impact resistance and low VOC emissions are required. The closed‑grain surface inhibits microbial growth, supporting hygiene standards.
| Property | Typical Value | Unit | Notes |
|---|---|---|---|
| Janka Hardness | 1,450 | lbf | Average; varies with grain direction. |
| Density | 42 | lb/ft³ | At 12% MC. |
| Thickness Tolerance | ±0.005 | in | After planing. |
| Finish Dry Film | 2‑3 | mils | UV‑cured polyurethane. |
| Moisture Content (MC) | 6‑9 | % | Target for installation. |
Yes. Thickness, width, length, and edge profile are adjusted according to project specifications. Custom widths up to 5 in are available upon request.
Required data include desired thickness, width, length range, finish type, stain color (if any), quantity, and delivery destination. Moisture content target and any special grading rules should also be supplied.
Each bundle undergoes moisture content verification, dimensional checks, surface inspection under defined lighting, and finish adhesion testing. Results are recorded and available to the buyer.
Standard packaging uses corrugated cartons with plastic edge protectors and a moisture‑barrier liner. For export, palletized stretch‑wrapped bundles with corner boards are offered.
Lead time ranges from 3 to 5 weeks for standard sizes, depending on order volume and current kiln capacity. Custom profiles may add 1‑2 weeks.
To discuss your specific hard maple flooring needs, provide the project details outlined above. Our engineering team will review the requirements and return a detailed quotation with lead‑time and packaging options.
Request Quotation