This flooring system is engineered for indoor courts that require consistent ball response, athlete safety, and long‑term durability under high‑impact use. The following sections detail the material makeup, performance metrics, installation considerations, and customization pathways that enable procurement teams to evaluate total cost of ownership.
The surface layer consists of a polyurethane‑based wear coat formulated to achieve a Taber abrasion loss of less than 80 mg per 1000 cycles under a 500 g load. Beneath this, a recycled rubber granule layer provides shock attenuation, measured at a peak force reduction of 30 % relative to concrete substrates. A moisture‑resistant polypropylene backing prevents delamination in environments with fluctuating humidity.
| Property | Typical Value | Test Standard |
|---|---|---|
| Overall Thickness | 12 mm | ASTM F2772 |
| Shock Absorption | ≥ 35 % | ASTM F2772 |
| Vertical Deformation | 0.5 mm – 0.8 mm | ASTM F2772 |
| Ball Rebound | 90 % – 95 % (relative to concrete) | ASTM F2117 |
| Slip Resistance (Wet) | ≥ 0.6 (µ) | ASTM E303 |
| Wear Resistance (Taber) | ≤ 80 mg/1000 cycles | ASTM D4060 |
The flooring is supplied in interlocking tiles measuring 500 mm × 500 mm with a tongue‑and‑groove edge. Installation requires a clean, level substrate; adhesive is optional for permanent venues, while a floating lay‑down suffices for temporary courts. Alignment tolerances are held within ±0.5 mm per tile to ensure uniform seam height.

Each production batch undergoes inline thickness gauging (±0.1 mm) and durometer hardness verification (Shore A 85 ± 5). Finished panels are subjected to a 10‑cycle impact test using a 5 kg steel ball dropped from 1.5 m; residual indentation must remain below 0.2 mm. Statistical process control charts monitor abrasion loss across shifts, triggering corrective action if the moving average exceeds 75 mg.
Yes. Custom cutting services are available; edge tiles can be fabricated to 250 mm increments while maintaining the interlocking profile.
Project dimensions, desired thickness, color or graphic specifications, installation environment (indoor/outdoor, humidity range), and preferred delivery timeline.
Standard aliphatic polyurethane, optional water‑based urethane for low VOC applications, and a ceramic‑enhanced variant for extreme abrasion resistance.
Each pallet receives a visual check for surface defects, a random thickness sampling (5 % of tiles), and a Taber abrasion test on a representative sample.
Tiles are stacked in corrugated cartons with corner protectors, then palletized and stretch‑wrapped; desiccant packs are included for humidity control.
Standard colors ship within 3‑4 weeks; custom graphics or special thicknesses extend lead time to 5‑6 weeks, subject to capacity.
To obtain a detailed cost estimate, please provide your project specifications via the contact form.
Contact Us